|
 |
|
|
See Reflok VRF pipeline
connection kit in action |
|
How Reflok
Works
This slideshow explains the basics behind the Reflok
VRF pipeline connection system. It shows how to connect
the pipes of an air conditioning system using the unique
Reflok connectors and components and also shows the contents
of the kits. |
|
|
|
|
Please click on the arrows to view slideshow |
|
|
Slide 1 of 11
The Reflok component toolbox kit is supplied
with eight popular joint sizes: 6mm/1/4",
8mm/5/16",
10mm/3/8", 12mm/1/2", 16mm/5/8",
19mm/3/4", 22mm/7/8", 28mm/11/8",
35mm/1 3/8", ratcheting crimping pliers,
required jaw sets, joint preparation fluid
and a tough carrying case. |
|
|
|
|
|
Slide 2 of 11
Making a Reflok joint is a simple process starting with the selection of the
appropriate jaw size for the Reflok connector and pipes to be joined. These simply
slot into the pliers and are held securely in place with locking pins. |
|
|
|
|
|
Slide 3 of 11
Select the Reflok connector to match your
pipe size. Shown here in its uncompressed state
a Reflok connector creates a perfect joint as
it is compressed using the pliers. |
|
|
|
|
|
Slide 4 of 11
The
Reflok connector locates in the pliers as shown,
one of the jaws will apply pressure to the outside
of the joint the other applying pressure to the
centre shoulder. |
|
|
|
|
|
Slide 5 of 11
Joint preparation fluid is then applied to the pipe to be joined. The anaerobic
fluid acts as an additional seal compensating for any slight imperfections in
the tube ensuring a perfect gas tight joint. |
|
|
|
|
|
Slide 6 of 11
The tube is then inserted into the Reflok connector in preparation for the crimping
process. |
|
|
|
|
|
Slide 7 of 11
The pliers are then operated to compress the Reflok connector and make the joint.
Because of their ratcheting action Reflok pliers can be used in difficult to
access and confined spaces. |
|
|
|
|
|
Slide 8 of 11
The crimping pliers incorporate articulating arms to provide access to confined
spaces and allow overhead joint making. |
|
|
|
|
|
Slide 9 of 11
As the pliers are worked the Reflok connector
compresses to create the perfect joint. |
|
|
|
|
|
Slide 10 of 11
The process is then repeated for the other side to complete the joint. The whole
process takes just a few minutes, is clean, gas tight in excess of 42 bar and
most importantly requires no heat. |
|
|
|
|
|
Slide 11 of 11
The process used can be repeated throughout the range to create joints from 6mm/1/4" to
35mm/1 3/8". |
|
|
|
|
